Hyundai Creta: Fuel Delivery System / Accelerator Pedal: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal: Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the mounting nuts (B).

Installation

Install in the reverse order of removal.

Accelerator pedal module mounting nut :

12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator pedal module mounting bolt :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly: Repair procedures

Removal 1. Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A). 2. Lift the vehicle. ...

Delivery Pipe: Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Release the residual pressure in fuel lin ...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Smart Key Unit
Components and components location Components Connector Pin Information No Connector A Connector B Connector C 1 BATT (+) Driver out side handle antenna (Ground) ESCL (ground) ...

Hyundai Creta GS 2014-2019 Service Manual: Auto Defogging Actuator
Components and components location Components Location 1. Auto defogging actuator Description and operation Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occur ...