Hyundai Creta: Fuel Delivery System / Delivery Pipe: Repair procedures

Hyundai Creta GS 2014-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Delivery Pipe: Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

Release the residual pressure in fuel line.

(Refer the fuel Delivery system - Repair Procedures - "Release Residual Pressure in Fuel Line")

•	When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Lin" work.

3.	Disconnect the injector connector (A).

4.	Remove the wiring harness bracket mounting bolt (B).

5.	Remove the mounting nut, and then disconnect the fuel feed tube (C).

6.	Remove the mounting bolt, and then remove the delivery pipe & injector assembly from the engine.

7.	Remove the fixing clip (A), and then separate the injector from the delivery pipe.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting

•	Apply the engine oil to the injector O-ring.

•	Inspect the injector O-ring when installing.

Install in the reverse order of removal.

Delivery pipe mounting bolt :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Delivery pipe mounting nut (↔ Fuel feed tube) :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Accelerator Pedal: Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the accelerator position senso ...

Clutch System

...

Other information:

Hyundai Creta GS 2014-2019 Service Manual: Special service tools
Special Service Tools Tool Name / Number Illustration Description Fuel Pressure Gauge 09353-24100 Used for measuring the pressure in fuel line Fuel Pressure Gauge Adapter 0935 ...

Hyundai Creta GS 2014-2019 Service Manual: Valve Body
Description and operation Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pressure regulator valves, oil redirection valves, shift valves ...