Hyundai Creta: Body Side Molding / Roof Rack: Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the roof rack front cover (A) and roof rack rear cover (B).
2.
After loosening the mounting nut, then remove the roof rack assembly (C).
Tightening torque :
5.9 ~ 6.4 N.m ( 0.6 ~ 0.65 kgf.m, 4.3 ~ 4.7 lb-ft )
3.
To install, reverse the removal procedure.
  
Replace any damaged clips.

1. Roof rack front cover
2. Roof rack rear cover
3. Roof rack assembly

Body Side Molding
...

Roof Side Molding: Repair procedures
Replacement    • Put on gloves to protect your hands. ...

Other information:

Hyundai Creta GS 2014-2020 Owners Manual: Electronic Stability Control (ESC)
The Electronic Stability Control (ESC) system helps to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC applies braking pressure to any one of the vehicle’s brakes and intervenes in the engine management ...

Hyundai Creta GS 2014-2020 Service Manual: Seat Belt Pretensioner (BPT)
Description and operation Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupan ...

© 2017-2020 www.hcrmangs.com