Hyundai Creta: Body Side Molding / Side Sill Molding: Repair procedures
| • |
Put on gloves to protect your hands.
|
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage.
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Loosen the side sill molding mounting screws.
|
| 2. |
Using a screwdriver or remover, remove the side sill molding (A).
|
| 3. |
To install, reverse the removal procedure.
| •
|
Replace any damaged clips.
|
|
|
Replacement
•
Put on gloves to protect your hands.
...
Other information:
Hyundai Creta GS 2014-2019 Service Manual: Knock Sensor (KS)
Description and operation
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block
and senses engine knocking.
When knocking occurs, the vibration from the cylind ...
Hyundai Creta GS 2014-2019 Owners Manual: Emission control system
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty
information contained in the Service
Passport in your vehicle.
Your vehicle is equipped with an
emission control system to meet all
emission regulations.
There are three emissi ...
Rear Mud Guard: Repair procedures
Mirror